Don Webb
Des de 5, 2019 09: 09
Here's how to mark the wires: take about 5 bare wires and twist them together evenly with me. Squeeze one end of the pliers, then put the other end into the sexe nina drill chuck until it is taught, and then slowly rotate until it is tightly wrapped (while keeping the teaching state.) Be careful not to overtighten the cover. The heat-shrinkable tube is then sleeved over it until it shrinks. Clamp the end to make it uneven, and then test with a finger line. You can add as many harnesses as needed to total 3.2 mm. The length of the wire should be at least about 6 inches. . Sorry, not sure about the length in CM. You know we are stuck with SAE cos here in the United States, and it takes some company funds to measure him. This twisting can also be done through the insulation on each wire. May help improve sex doll durability.
